ARC DECORATORS FILLER CAULK WHITE 380ML
Price: €3.50
You must enable Javascript in your browser to use this website.
Click here to find out howPrice: €3.50
Arc Painters Filler (380ml) is an acrylic sealant which provides a flexible long lasting seal that adheres to virtually all materials, can be overpainted.
Uses
- Sealing around timber and metal window and door frames.
- PVCu profile, trim and cladding.
- Internal sealing around PVCu window and door frames.
- Sealing cracks and gaps in brickwork, stone and concrete.
- An adhesive for bonding polystyrene coving and tiles.
- Gap and crack filler prior to decorating.
SUBSTRATE PREPARATION
All surfaces must be clean and dust free. All loose or flaking surface coatings, and old sealant and mastic joints, should be removed before application. Highly porous substrates such as new plaster should first be primed with Arc PVA bond diluted 1:4 with water. This product can be applied to slightly damp, but not wet surfaces.
APPLICATION METHOD / TOOLS
Cut the tip of the cartridge taking care not to damage the thread. Apply nozzle and cut cleanly at an angle of 45° with an opening slightly larger than the gap to be sealed. Apply using a standard sealant gun. Best results will be obtained by keeping an even pressure on the gun trigger and keeping the gun at a constant angle to the surface being sealed. Smooth down within 20 minutes of application using a wetted spatula, piece of wood or wetted gloved finger. Care should be taken at this point not to saturate the surface as this will delay drying. Any excess sealant etc., can be removed using a sponge and warm water. Can be overpainted after approximately 1 hour.
Joint design should be as follows:
Minimum width: 6mm. Movement capacity will be impaired if the depth of the joint is greater than the width. For maximum movement accommodation, it is recommended that: The joint depth should be no less than 5mm Joint depth should be 5mm for joints up to 10mm wide Joints above 10mm in width should be half the width in depth up to 20mm and minimum 10mm for wider joints For deep joints, reduce depth by using Arc Foam or a suitable joint backer rod. All joints should be designed so that the seal is placed in a position which does not retain water or form a water trap. Triangular fillets should be no less than 12mm across the face and should be finished with a flat or convex face.